NEC Electra Elite IPK - Start Time Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 9
___________________________________________________________________________________
___________________________________________________________________________________
1-1-05 Start Time Selection
General Description
Use this Memory Block to specify the time after dialing before the system starts the
Elapsed Call Time. Used for copper trunks only. Not supported by digital trunks.
This Memory Block can be adjusted in 1-second intervals (R3000 or higher).
Display (R2500 or lower)
Settings
Refer to the next page for R3000 or higher Programming Procedures.
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
10s 20s 30s 40s 50s 60s 70s 2s
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK1 + KE to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
System Mode
1
Submode
1
Data No.
05
PC Programming
¦ +BM
0 5 : C A L L S T A R T 1 0 s
T I M E D I S P L A Y
Data
No.
Title
Setting
Data