NEC Electra Elite IPK - Dial 1 (DP) Hookflash Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 141
___________________________________________________________________________________
___________________________________________________________________________________
1-3-04 Dial 1 (DP) Hookflash Selection
General Description
Use this Memory Block to specify whether or not a dial pulse (DP) Single Line
Telephone provides a hookflash signal when the user presses 1 during an intercom or
CO/PBX call.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
YS NO
Programming Procedures
1 Go off-line.
2 Press LK1 + LK3 +
KD to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
4-90
SLT Data Line Security Assignment
4-95
DTMF/DP SLT Type Selection
System Mode
1
Submode
3
Data No.
04
PC Programming
¦ +BTI
0 4 : D I A L 1 F L S H Y S
T I M E D I S P L A Y
Setting
Data
Title
Data
No.