NEC Electra Elite IPK - LCR Class Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 551
___________________________________________________________________________________
___________________________________________________________________________________
4-40 LCR Class Selection
General Description
Use this Memory Block to specify per station the Least Cost Routing (LCR) Class. The
Electra Elite IPK system has four Area Code Tables. Each LCR Class can have
different Trunk group access to allow priority levels for the station user. This Memory
Block can be used to specify either the LCR Class or the Automatic Route Selection
(ARS) Class (Tables 1~4) depending on the system configuration.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
Numbers are
LCR Classes.
01234
Programming Procedures
1 Go off-line.
2 Press LK4 +
DK to access the Memory Block.
3 Press line key to specify LCR Class for Tel Port No.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B + A to enter A for Port Numbers 100~109
B + B to enter B for Port Numbers 110~119
B + C to enter C for Port Number 120
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Telephone Mode
4
Submode
—
Data No.
40
PC Programming
¦ +BTT
0 1 / 4 0 : L C R C L S = 0
T I M E D I S P L A Y
Tel
Port
No.
(01
~ C0)
Title
Setting
Data
Data
No.