NEC Electra Elite IPK - Line Key Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 417
___________________________________________________________________________________
___________________________________________________________________________________
2-05 Line Key Selection
General Description
Use this Memory Block to select Tenant-Wide Mode or Telephone Mode line key
assignment for each tenant.
Display
Settings
 Notes 
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
TNAT TEL
Programming Procedures
1 Go off-line.
2 Press LK2 +
KE to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option to TNAT.
4 Press
G to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
2-06
Line Key Selection for Tenant Mode
4-12
Line Key Selection for Telephone Mode
1. Mixed use of Tenant-Wide Mode and Telephone Mode is permitted in the system.
2. Tenant-Wide Mode:
Memory Block 2-06 (Line Key Selection for Tenant Mode) permits assignment of any desired feature to each of
the CO/PBX line keys. All the telephones in a tenant are assigned the same features.
3. Telephone Mode:
Memory Block 4-12 (Line Key Selection for Telephone Mode) permits assignment of any feature to each of the
CO/PBX line keys. Each telephone can be assigned different features.
Tenant Mode
2
Submode
—
Data No.
05
PC Programming
¦ +BN
0 0 / 0 5 : M O D E T E L
T I M E D I S P L A Y
Data
No.
Setting
Data
Tenant
No.
(00~47)
Title