NEC Electra Elite IPK - Line Key Selection for Tenant Mode

2 - 418 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
2-06 Line Key Selection for Tenant Mode
General Description
Use this Memory Block to assign functions to each CO/PBX line key on each
telephone in a tenant specified as Tenant Mode in Memory Block 2-05 (Line Key
Selection).
Display
Settings
Page 1
LK 1 LK 2LK 3LK 4LK 5LK 6LK 7LK 8
The shaded
selection is the
default.
NON
CO
(CO/PBX)
FW BNA FW ALL
Call
Appearance
Key
Feature
Access Key
TKGP
Route
Advance
Page 2
LK 9 LK102 LK 11 LK 12 LK 13 LK 14 LK 15 LK 16
SIE Microphone H SET
SCROLL
(ANI/Caller
ID)
DND
(On/Off)
LOG
(On/Off)
BGM
(On/Off)
ICM
Programming Procedures
1 Go off-line.
2 Press LK2 +
KF to access the Memory Block. Verify that Memory Block 2-05 is set to TNAT.
3 Press the corresponding CO/PBX line key to select the function for Line Key No. 01. When indicated, add Setting Data 2 using
dial keys.
4 Press
G to write data and display Line Key No. 2.
5 Repeat Steps 3 and 4 for each Line Key assignment. After Line Key No. 24 is programmed, the next Memory Block is displayed.
6 Program the next Memory Block or press
E to go back on-line.
Tenant Mode
2
Submode
—
Data No.
06
PC Programming
¦ +BN
0 0 / 0 6 : L 0 1 = C O 0 1
T I M E D I S P L A Y
Data
No.
Setting
Data
1
Tenant
No.
(00~47)
Line
Key
(01~24)
Setting
Data
2
Page