NEC Electra Elite IPK - CO;PBX Telephone Ringing Pattern Selection

2 - 572 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
4-55 CO/PBX Telephone Ringing Pattern
Selection
General Description
Use this Memory Block to specify the ringing pattern assigned to each telephone.
Display
Settings
Page 1
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
The shaded
selection is the
default.
—
( None)
Ringing
Pattern A
Ringing
Pattern B
Ringing
Pattern C
Ringing
Pattern D
Ringing
Pattern E
Ringing
Pattern F
Ringing
Pattern G
Page 2
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
Ringing
Pattern H
Programming Procedures
1 Go off-line.
2 Press LK4 +
EE to access the Memory Block.
3 Press the corresponding CO/PBX line key to select the ringing pattern for Tel Port No.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
C to go to the next page
A to go to the previous page
B + A to enter A for Port Numbers 100~109
B + B to enter B for Port Numbers 110~119
B + C to enter C for Port Number 120
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
CO/PBX Line Mod
e
4
Submode
—
Data No.
55
PC Programming
¦ +BTT
0 1 / 5 5 : C O R N G – | 1
T I M E D I S P L A Y
Tel Po rt
No.
(01~CO)
Data
No.
Title
Setting
Data
Page