NEC Electra Elite IPK - Common Signaling Channel Route Assignment

Electra Elite IPK Document Revision 4
Programming Manual 2 - 615
___________________________________________________________________________________
___________________________________________________________________________________
5-05 Common Signaling Channel Route
Assignment
General Description
Use this Memory Block to specify the Common Signaling Channel for each voice trunk
group used for K-CCIS.
Programming Procedures
1 Go off-line.
2 Press LK5+
G + KE to access the Memory Block.
 Use the following to enter data:
J to move cursor left
L to move cursor right
K ~ I to enter numeric data
Default Values
:
0 (Not Assigned)
CCH: 1~4
3 Press G to write the data.
4 Press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
3-70
CIC Number Assignment
1-1-05
Start Time Selection
1-1-46~48
Access Code (1-, 2- or 3-Digit) Assignment
1-15-00
K-CCIS Main/Remote Office Selection
1-15-01
Common Signal Channel Data Speed Assignment
1-15-02
Common Signal Channel Assignment
1-15-03
Originating Point Code Assignment
1-15-04
Destination Point Code Assignment
1-15-05
Destination Point Code Transfer Assignment
1-15-06
Originating Office Code Number Assignment
1-15-07
K-CCIS Message Response Time Assignment
1-15-08
Link Reconnect Allow/Deny Selection
Trunk Group Mode
5
Submode
Data No.
05
PC Programming
¦ +AW
0 1 / 0 5 : C C H C H 0
T I M E D I S P L A Y
Trunk
Group
(01~32)
Setting
Data
Title
Data
No.