NEC Electra Elite IPK - Automatic Callback Release Time Selection

2 - 108 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-2-02 Automatic Callback Release Time
Selection
General Description
Use this Memory Block to specify the time allowed for an automatic callback before
the request is automatically canceled.
This Memory Block can be adjusted in 1-minute intervals (R3000 or higher).
Display (R2500 or lower)
Settings
Refer to next page for R3000 or higher Programming Procedures.
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8 The shaded
selection is the
default.
30s 1m 2m 3m 5m 10m 20m 30m
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK2 + KB to access the Memory Block.
3 Press the corresponding CO/PBX line key to change data option.
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
System Mode
1
Submode
2
Data No.
02
PC Programming
¦ +BM
0 2 : C A L L B A C K 3 0 m
T I M E D I S P L A Y
Setting
Data
Title
Data
No.