NEC Electra Elite IPK - Automatic Tandem Trunk Assignment

2 - 432 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
3-06 Automatic Tandem Trunk Assignment
Use this Memory Block to specify the incoming trunk and outgoing trunk for Automatic
Trunk-to-Trunk Transfer.
Display
Programming Procedures
1 Go off-line.
2 Press LK3 +
G + KF to access the Memory Block.
3 Enter the outgoing trunk number for incoming CO/PBX No.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
Default Values
Not Specified
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
3-04
Trunk-to-Trunk Transfer Yes/No Selection
3-05
Trunk Incoming Answer Mode Selection
CO/PBX Line Mod
e
3
Submode
—
Data No.
06
PC Programming
¦ +AT
0 1 / 0 6 : T A N D C O =
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
(Incoming)
CO/PBX
No.
(01~64)