NEC Electra Elite IPK - Automated Attendant Message Access Code (1-Digit) Assignment

2 - 166 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-4-14 Automated Attendant Message Access
Code (1-Digit) Assignment
General Description
Use this Memory Block to specify a 1-digit code to route an incoming call from the
Automated Attendant.
Display
.
Related Programming
Refer to individual features in the Electra Elite IPK Features and Specifications Manual.
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 +
JJAD to access the Memory Block.
3 Use the dial pad to enter function code for AA MSG. 1, Dial No. 0.
Use
K ~ I to enter the function code.
 Setting Data (Allowed):
Function Code 001~053
000 is unused.
4 Press
G to write the data and advance to the next dial number.
5 Repeat Steps 3 and 4 for each Dial No. AA MSG. 2, Dial No. 0 is displayed.
6 Repeat Steps 3 and 4 for each Dial No. AA MSG. 3, Dial No. 0 is displayed.
7 Continue this cycle for all Dial NOs. for all messages. The next Memory Block is displayed.
8 Program the next Memory Block or press
E to go back on-line.
System Mode
1
Submode
4
Data No.
14
PC Programming
¦ +AU
1 4 : A A A C 1 - O = 0 3 0
T I M E D I S P L A Y
Data
No.
AA MSG.
(1~8)
Title
Function
Code
DIAL.
No.
(0~9)
Default Values
Dial
Number
Function
Code
Contents
0 030 Specified
Station Call (0)
1 010 Station Number
2 010 Station Number
3 010 Station Number
4 ~ 9 000 Unregistered