NEC Electra Elite IPK - Trunk Internal Receive Pad Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 461
___________________________________________________________________________________
___________________________________________________________________________________
3-30 Trunk Internal Receive Pad Selection
General Description
Use this Memory Block to specify a dB volume level for calls coming to extensions of a
local system from a distant system.
Display
Settings
Page 1
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
The shaded
selection is the
default. Settings
are in dB.
246812163-3
Page 2
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
0
Programming Procedures
1 Go off-line.
2 Press LK3 +
G + CK to access the Memory Block.
3 Press the corresponding CO/PBX line key to change internal receive pad for CO/PBX No.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
C to go to the next page
A to go to the previous page
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
CO/PBX Line Mod
e
3
Submode
—
Data No.
30
PC Programming
¦ +BCT
0 1 / 3 0 : P A D I R 8 | 1
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Setting
Data
Page