NEC Electra Elite IPK - External Speaker Chime Start Time Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 205
___________________________________________________________________________________
___________________________________________________________________________________
1-7-09 External Speaker Chime Start Time
Selection
General Description
Use this Memory Block only when paging alert tone (four tones) is assigned in
Memory Block 1-7-08 (External Speaker Chime Selection). This Memory Block
specifies the delay time (in milliseconds) after an external paging code is dialed before
the paging alert tone is provided.
Display
Settings
Page 1
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
The shaded
selection (in ms)
is the default.
000 100 200 300 400 500 600 700
Page 2
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
800 900 1000 1100 1200 1300 1400 1500
Programming Procedures
1 Go off-line.
2 Press LK1 + LK7 +
KI to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
 Use the following when entering data:
A or C to cycle between pages, + to go from page 2 to page 1, = to go from page 1 to page 2
4 Press
G to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-7-08
External Speaker Chime Selection
System Mode
1
Submode
7
Data No.
09
PC Programming
¦ +BP
0 9 : S T A R T = 7 0 0 | 1
T I M E D I S P L A Y
Setting
Data
Title
Data
No.