NEC Electra Elite IPK - CO;PBX Incoming Ringing Alarm Time Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 11
___________________________________________________________________________________
___________________________________________________________________________________
1-1-06 CO/PBX Incoming Ringing Alarm
Time Selection
General Description
Use this Memory Block to specify the time between when a CO/PBX call is detected
and the ringing tone changes to a higher pitch when the call is not answered. When
No Limit is selected, the ringing tone does not change.
This Memory Block can be adjusted in 1-second intervals (R3000 or higher).
Display (R2500 or lower)
Settings
Refer to the next page for R3000 or higher Programming Procedures.
LK 1 LK 2 LK 3 LK 4LK 5LK 6LK 7LK 8
The shaded
selection is the
default.
10s 20s 30s
∞
(No Limit)
Programming Procedures
1 Go off-line.
2 Press LK1 +
LK1 + KF to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
System Mode
1
Submode
1
Data No.
06
PC Programming
¦ +BM
0 6 : R I N G A L M
∞
T I M E D I S P L A Y
Setting
Data
Title
Data
No.