NEC Electra Elite IPK - Trunk Group Outgoing Priority Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 617
___________________________________________________________________________________
___________________________________________________________________________________
5-06 Trunk Group Outgoing Priority
Selection
General Description
Use this Memory Block to assign the Outgoing Priority for trunk access to each Trunk
Group. This is normally used with a Tie Line or K-CCIS network to reverse the search
order and reduce call collisions during trunk seizure.
Display
Settings
 Notes 
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
The shaded
selection is the
default.
H → L
High to Low
L → H
Low to High
Programming Procedures
1 Go off-line.
2 Press LK5 +
G + KF to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press
G to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-46~48
Access Code (1-, 2- or 3-Digit) Assignment
Function 201~232 – Route Advance Block 01~32
Function 401~416 – Closed Number Block 01~32
Function 601~604 – ARS Table 1~4
1-1-30
Route Advance Block Assignment
1-1-49
Networking Trunk Group/Route Advance Assignment
1-14-04
ARS Trunk Group to Route Number Assignment
This Memory Block should not be assigned (use default) for trunk groups with trunks belonging to an IAD(8)-U( )
ETU used with IP (K-CCIS) or IP (K-CCIS) to NEAX (Point-to-Multipoint).
Trunk Group Mod
e
5
Submode
Data No.
06
PC Programming
¦ +ALN
0 1 / 0 6 : P R I O R . H > L
T I M E D I S P L A Y
Trunk
Group
(01~32)
Setting
Data
Title
Data
No.