NEC Electra Elite IPK - Intercom Feature Access Code Assignment

2 - 126 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-2-24 Intercom Feature Access Code
Assignment
General Description
Use this Memory Block to assign the Access Code for Voice/Tone change or Step
Call.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK2 +
BD to access the Memory Block.
3 Use the dial pad to enter the Setting Data.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data
B + , or # to enter , or #
4 Press G to write the data and advance to the next Dial No.
5 Repeat Steps 3 and 4 for each Dial No. The next Memory Block is displayed.
6 Program the next Memory Block or press
E to go back on-line.
System Mode
1
Submode
2
Data No.
24
PC Programming
¦ +BA
2 4 : F E A A C ( 0 ) = 0 0 4
T I M E D I S P L A Y
Setting
Data
Title
Data
No.
Dial
No.
Setting Data
Setting Code Feature
000 Not Used
001 Voice/Tone Switching
002 Step Call
003 Tone Override
004 Automatic Callback
005 Callback Request
006 Voice Over Originate
007 Quick Transfer to Voice Mail
Default Values
Dial Numbers
0 = 004
1 = 001
2 = 002
3~5 = 000
6 = 006
7 = 007
8, 9 = 000
, = 003
# = 005