NEC Electra Elite IPK - Page 202

Electra Elite IPK Document Revision 4
Programming Manual 2 - 125
___________________________________________________________________________________
___________________________________________________________________________________
Display (R3000 or higher)
 Notes 
Programming Procedures
1 Go off-line.
2 Press LK1 + LK2 +
BC to access the Memory Block.
3 Use the dial pad to enter the Data Setting for Class 1.
Setting Data
001s~999s (e.g., 120s = 2 Minutes)
Default Values
Class 1~4 = 060s
4 Press G to write the data and display the next Timer Class of Service.
5 Program the next Timer Class of Service or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
4-71 Station to Timer Class of Service
1. Telephone Ports 1 and 2 are in Station to Timer Class of Service, Class 1, by default. All other ports are in
Station to Timer Class of Service, Class 2, by default.
2. When a system is upgraded from R2500 or lower to R3000 or higher, the System Call Park Recall Time
Selection is reset to the default during the upgrade process.
2 3 : P R K R C L 1 = 0 6 0 s
T I M E D I S P L A Y
T
i
me
r
C
la
s
s
1
~
4
Title
Data
No.
Setting
Data