NEC Electra Elite IPK - HFU Selection

2 - 538 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
4-29 HFU Selection
General Description
Use this Memory Block to enable/disable per station the built-in Handsfree HFU-U
Unit.
Display
Settings
 Notes 
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
NO YS
Programming Procedures
1 Go off-line.
2 Press LK4 +
BI to access the Memory Block.
3 Press LK2 if you want to enable the HFU-U Unit for Tel Port No.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B + A to enter A for Port Numbers 100~109
B + B to enter B for Port Numbers 110~119
B + C to enter C for Port Number 120
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Telephone ports A0~C0 are ports 100~120.
Telephone Mode
4
Submode
—
Data No.
29
PC Programming
¦ +BTM
Data
No.
0 1 / 2 9 : H F U N O
T I M E D I S P L A Y
Tel
Port
No.
(01
~ C0)
Table
Setting
Data