NEC Electra Elite IPK - IP Telephone Block Assignment Allow;Deny Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 133
___________________________________________________________________________________
___________________________________________________________________________________
1-2-33 IP Telephone Block Assignment
Allow/Deny Selection
General Description
Use this Memory Block to designate whether or not Memory Block 1-2-32 (IP
Telephone Block Assignment) is used. When this Memory Block is set to YS (Allow),
Memory Block 1-2-32 can be used to assign IP Telephones to connect to the
IPCA( )-U( ) ETU to use resources from the CPUI( )-U( ) (Legacy system). When
this Memory Block is set to NO (Deny), Memory Block 1-2-32 cannot be assigned.
System Software R2500 is required.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
YS (Allow) NO (Deny)
Programming Procedures
1 Go off-line.
2 Press LK1 + LK2 +
CC to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
System Mode
1
Submode
2
Data No.
33
PC Programming
¦ +AH
3 3 : I P A S S I G N Y S
T I M E D I S P L A Y
Title
Data
No.
Setting
Data