NEC Electra Elite IPK - CO;PBX Prepause Time Selection

2 - 76 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-1-57 CO/PBX Prepause Time Selection
General Description
Use this Memory Block to assign a pause time before dialed digits can be sent over a
CO/PBX line after the trunk is seized by a system user.
Settings
Page 1
LK 1 LK 2LK 3LK 4LK 5LK 6LK 7LK 8
The shaded
selection is the
default.
NON 1s 2s 3s 4s 5s 6s 7s
Page 2
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
8s 9s 10s 11s 12s 13s
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 +
EG to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
 Use the following to change page:
C to move to next page
A to move to previous page
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
System Mode
1
Submode
1
Data No.
57
PC Programming
¦ +BCM
5 7 : P R E P A U S E 1 s | 1
T I M E D I S P L A Y
Data
No.
Title
Page
No.
Setting
Data