2 - 606 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
4-95 DTMF/DP SLT Type Selection
General Description
Use this Memory Block to specify per port whether Dial Pulse or Dual-Tone
Multifrequency (MF) Single Line Telephone is connected to the system.
Display
Settings
LK 1 LK 2LK 3LK 4LK 5LK 6LK 7LK 8The shaded
selection is the
default.
DP MF
Programming Procedures
1 Go off-line.
2 Press LK4 +
IE
to access the Memory Block.
3 Press LK1 to specify Dial Pulse for single line telephones connected to the system.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B +
A
to enter A for Port Numbers 100~109
B +
B
to enter B for Port Numbers 110~119
B +
C
to enter C for Port Number 120
4 Press
G to write the data and display the next Tel Port No. for Memory Block 4-90.
5 Repeat Steps 3 and 4 for all Tel Port Nos. Tel Port No. 01 for Memory Block 4-90 is displayed.
Telephone Mode
4
Submode
—
Data No.
95
PC Programming
¦
+BTI
Data
No.
0 1 / 9 5 : S L T = M F
T I M E D I S P L A Y
Tel
Port
No.
(01
~
C0)
Title
Setting
Data
To Next Page
Loading...
