NEC Electra Elite IPK - Tie Line First Ring Pattern Selection

2 - 46 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-1-34 Tie Line First Ring Pattern Selection
General Description
Use this Memory Block to set a specific ringing pattern for incoming calls on Tie lines.
After a delay interval specified in Memory Block 1-1-07 (Tie Line Delay Ringing Time
Selection), a Tie call can ring at all Day/Night ring-assigned telephones using a
different cadence.
Display
Settings
 Notes 
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
PAT1 PAT2 PAT3 PAT4 ICM VOICE
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 +
CD to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-07
Tie Line Delay Ringing Time Selection
1-1-53
Tie Line Delay Ring Pattern Selection
4-01
CO/PBX Ring Assignment (Day Mode)
4-02
CO/PBX Ring Assignment (Night Mode)
1. Specify one pattern in the Ringing Pattern Selection Table.
2. When Voice is selected, switching from voice to tone is not allowed, Memory Block 1-1-07 (Tie Line Delay
Ringing Time Selection) is not used, and Handsfree Answerback is not allowed at the receiving station.
System Mode
1
Submode
1
Data No.
34
PC Programming
¦ +ALN
3 4 : T L I R N G P A T 3
T I M E D I S P L A Y
Setting
Data
Title
Data
No.