NEC Electra Elite IPK - System Speed Dial Memory Clear

2 - 642 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
8-2 System Speed Dial Memory Clear
General Description
Use this Memory Block to clear all System Speed Dial programming.
Display
Programming Procedures
1 Go off-line.
2 Press LK8 + LK2
to access the Memory Block.
3 The system display indicates CLR SYS SPD?, and the first four CO/PBX lines light red.
4 Press
HAHI to enter the fixed password.
 When each number of the password is being entered, the applicable top line CO/PBX LED changes from red to green.
5 Press
G to write the data.
6 Press
E to go back on-line.
Special Mode
8
Spd-Clr-Sys
2
Data No.
—
PC Programming
¦ +BE
Before using this procedure, understand completely the affect of erasing al
l
System Speed Dial buffers in the system.
C L R S Y S S P D ?
T I M E D I S P L A Y
Title
RRRR
WWWW
GRRR
H
=
WWWW
GGRR
A
=
WWWW
GGGR
H
=
WWWW
GGGG
I
=
WWWW