NEC Electra Elite IPK - 911 - Cut through Trunk Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 491
___________________________________________________________________________________
___________________________________________________________________________________
3-69 911 – Cut Through Trunk Selection
General Description
Use this Memory Block to specify which trunk or trunks are released when a 911 call is
placed.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
NO YES
Programming Procedures
1 Go off-line.
2 Press LK3 +
G + FI to access the Memory Block.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
Default Values
CO/PBX No. 01~64 = NO
3 Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press
G to write the selected data and display next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
CO/PBX Line Mod
e
3
Submode
—
Data No.
69
PC Programming
¦ +AE
0 1 / 6 9 : 9 1 1 D R O P N O
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Setting
Data
Title