NEC Electra Elite IPK - Intercom Ring Tone Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 119
___________________________________________________________________________________
___________________________________________________________________________________
1-2-20 Intercom Ring Tone Selection
General Description
Use this Memory Block to select a ring tone for intercom calls.
Display
Settings
 Notes 
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
A B C D E F G H
Programming Procedures
1 Go off-line.
2 Press LK1 + LK2 +
BK to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
The available tones are:
Tone A = (480/600):
Tone B = (480/606):
Tone C = (1024/1285)
Tone D = (1024)
Tone E = (500)
Tone F = (1024/1285):
Tone G = (600/700):
Tone H = (1024)
Modulation (16 Hz)
Modulation (8 Hz)
Modulation (16 Hz)
Modulation (16 Hz)
Envelope 2 sec.
System Mode
1
Submode
2
Data No.
20
PC Programming
¦ +BI
2 0 : I C M T O N E A
T I M E D I S P L A Y
Setting
Data
Title
Data
No.