NEC Electra Elite IPK - Intercom Ring Pattern Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 117
___________________________________________________________________________________
___________________________________________________________________________________
1-2-19 Intercom Ring Pattern Selection
General Description
Use this Memory Block to select a ring pattern or turn the tone ON/OFF when intercom
calls are made.
Display
Settings
Page 1
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded
selection is the
default.
OFF ON A B C DE F
Page 2
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
G H
Programming Procedures
1 Go off-line.
2 Press LK1 + L2 +
AI to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
 Use the following to enter data:
C to go to the next page
A to go to the previous page
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
System Mode
1
Submode
2
Data No.
19
PC Programmin
g
¦ +BI
1 9 : I C M P T N B | 1
T I M E D I S P L A Y
Page
Setting
Data
Data
No.
Title