Electra Elite IPK Document Revision 4
Programming Manual 2 - 513
___________________________________________________________________________________
___________________________________________________________________________________
4-10 Station Number Assignment
General Description
Use this Memory Block to assign a station number to each telephone.
R2500 is required for 5-, 6-, or 7-digit Extension Numbers.
Display (R1700 or lower)
Display (R2000 or higher)
The number displayed after the leading digits is from Memory Block 1-2-34 (Expanded Station Number Assignment) when
assigned (R2500 is required).
Programming Procedures
1 Go off-line.
2 Press LK4 +
AK
to access the Memory Block.
3 Use dial pad to assign a 2- (10
~89), 3- (100~899), 4-digit (1000~8999), or 5~7, 4-digit
(0000
~9999) station number for Tel Port No.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B +
A
to enter A for Port Numbers 100~109
B +
B
to enter B for Port Numbers 110~119
B +
C
to enter C for Port Number 120
Default Values
Valid Station Numbers are 100~399.
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Telephone Mode
4
Submode
—
Data No.
10
PC Programming
¦
+BS
0 1 / 1 0 : S T A - 1 0 0
T I M E D I S P L A Y
Title
Tel
Port
No.
(01
~
C0)
Setting
Data
Data
No.
0 1 / 1 0 : S T A X X X 1 0 0
T I M E D I S P L A Y
Title
Tel
Port
No.
(01
~
C0)
Setting
Data
Data
No.
To Next Page
Loading...
