NEC Electra Elite IPK - DISA ID Code Assignment

Electra Elite IPK Document Revision 4
Programming Manual 2 - 261
___________________________________________________________________________________
___________________________________________________________________________________
1-9-00 DISA ID Code Assignment
General Description
Use this Memory Block to specify the Direct Inward System Access (DISA) ID Code
number.
Display
 Notes 
Programming Procedures
1 Go off-line.
2 Press LK1 + LK9
to access the Memory Block.
3 Use the dial pad to enter the data.
 Setting Data:
2-digit DISA ID Code: 00~99 (00 no data)
3-digit DISA ID Code: 000~999 (000 no data)
4-digit DISA ID Code: 0000~9999 (0000 no data)
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data
D to access the next assigned ID buffer number or cycle back to 1
B + 1, 2, 3 = A, B, or C for Port Number
 ID Buffer Number:
01~99
A0~A9
B0~B9
C0
4 Press
G to write the data. Memory Block 1-9-02 is displayed.
5 Repeat Steps 3 and 4 for each remaining sequential ID Buffer No. displayed after each password choice is made in Memory
Block 1-9-02.
1. Assign 000 (No Data) for stations that are not installed or stations that are denied DISA access.
2. This Memory Block cycles through ID Buffer Nos. alternating with Memory Block 1-9-02 password specification
for each Buffer No.
System Mode
1
Submode
9
Data No.
00
PC Programming
¦ +BD
0 1 / 0 0 : C O D E = 0 0 0 0
T I M E D I S P L A Y
ID Buffer
No.
(01~C0)
Title
Data
No.
Setting
Data
Default Values
If DISA ID Code is assigned as 2-digit:
ID Buffer Number 01~10 = Code 10
ID Buffer Number 11~20 = Code 11
Thru
ID Buffer Number B1~C0 = Code 21
If DISA ID Code is assigned as 3-digit:
ID Buffer Number 01~C0 = Code 100~21
9
If DISA ID Code is assigned as 4-digit:
ID Buffer Number 01~C0 = Code 1000
and in 10s increments to 2190