NEC Electra Elite IPK - SLT or Automated Attendant;Disa to CPU PBR Selection

Electra Elite IPK Document Revision 4
Programming Manual 2 - 207
___________________________________________________________________________________
___________________________________________________________________________________
1-8-01 SLT or Automated Attendant/DISA to
CPU PBR Selection
General Description
Use this Memory Block to specify whether the four Push Button Receiver (PBR)
circuits in the CPUI( )-U( ) ETU are used for Single Line Telephones or Automated
Attendant/Direct Inward System Access (DISA).
Display
Settings
 Notes 
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
Default not
assigned.
PBR 1
and 2
PBR 3
and 4
Programming Procedures
1 Go off-line.
2 Press LK1 + LK8 to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
The LED indication changes to indicate the data each time the CO/PBX line key is pressed.
4 Press
G to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
E to go back on-line.
When LK1 and LK2 are assigned to Automated Attendant/DISA, a PBR( )-U( ) ETU must be installed in the
system when Single Line Telephones are used.
System Mode
1
Submode
8
Data No.
01
PC Programming
¦ +BTI
0 1 : P B R ( S L T / A A )
T I M E D I S P L A Y
Title
Data
No.
CO/PBX
Line LED
Off On
Data
Single Line Telephone A.A./DISA
The shaded area
indicates the default
setting.