Electra Elite IPK Document Revision 4
Programming Manual 2 - 393
___________________________________________________________________________________
___________________________________________________________________________________
1-16-07 High Priority RX Tag Threshold
General Description
The HUB(8) has two queues: High Priority and Low Priority. When Memory Block
1-16-06 is set to NO, and the priority of the VLAN tag is equal to or greater than the
setting in this block, the tag is queued for high priority. Otherwise, it is queued for low
priority. When it is transmitted out the egress port of the HUB(8), it retains its original
VLAN tag priority value.
R1500 or higher is required.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK16 +
JJKG
to access the Memory Block.
3 Use dial pad keys to enter Setting data.
Use the following to enter data:
Use
J
to move cursor left
Use
L
to move cursor right
Use
K
~
I
to enter numeric data
Priority range is lowest 0~7 highest.
Default Values
:
All ports = 7
4 Press G to write the data.
5 Repeat steps 3 and 4 for each HUB(8)-U( )
ETU port.
6 Press
E to go back on-line.
System Mode
1
Submode
16
Data No.
07
PC Programming
¦
+AB
0 7 : 1 - 1 H I G H R X = 7
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
PORT
1~8
HUB
1~3
To Next Page
Loading...
