NEC Electra Elite IPK - Page 136

Electra Elite IPK Document Revision 4
Programming Manual 2 - 59
___________________________________________________________________________________
___________________________________________________________________________________
 Notes 
1. Select options from the list of function numbers in Memory Block 1-1-46 [Access Code (1-Digit) Assignment], and
assign a number (from 00~99),
, , or # to each selected function.
H When a function is assigned a 1-digit Access Code, 2-digit Access Codes with the same first digit become
invalid (i.e., if a function is assigned to Access Code 5, Access Codes 50~59, 5
, , and 5# cannot be used).
2. To enter
# or , as part of an Access Code, press B then L or J .
3. Use this Memory Block when a 4-Digit Station Numbering Plan is programmed.
4. When function 001 (Station Number) is assigned in this memory block, it cannot be assigned in Memory Block
1-1-46 [Access Code (1-Digit) Assignment] or Memory Block 1-1-48 [Access Code (3-Digit) Assignment].