NEC Electra Elite IPK - Page 477

2 - 400 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
 Notes 
Related Programming
M.B. Number Memory Block Name
7-1
Card Interface Slot Selection
1-16-00
Auto Negotiation Yes/No Selection
1-16-01
Port Speed Selection – 10/100 Base T
1-16-02
Port Duplex Mode Selection
1-16-03
MDI/MDIX Mode Selection
1-16-04
VLAN Mode Selection
1-16-05
Default VLAN ID Tag Insertion Assignment
1-16-06
Port Based Priority Selection
1-16-07
High Priority RX Tag Threshold
1-16-08
High Priority TX Tag Assignment
1-16-09
Low Priority TX Tag Assignment
1-16-11
Mirroring Source Port Assignment
1-16-12
Mirroring Target Port Assignment
1-16-13
VLAN Group to VLAN ID Assignment
1-16-14
Port VLAN Group Membership
1-16-15
VLAN Tag Insertion Selection
1-16-16
Flow Control for Full Duplex Selection
1-16-17
Back Pressure for Half Duplex Selection
1. Only one HUB(8)-U( ) ETU can be assigned and installed for each cabinet.
2. The HUB(8)-U( ) ETU is an eight-port switching HUB. One port can be set as a source port, and one port can be
set as a target port for port mirroring to monitor traffic data.
3. To allow this function, set this Memory Block to YS, and program Memory Block 1-16-11 (Mirroring Source Port
Selection) and Memory Block 1-16-12 (Mirroring Target Port Selection).
4. When mirroring data to a PC for protocol analysis, an 802.1q/p-aware network interface card is required to
capture tagged frames.