NEC Electra Elite IPK - Page 674

Electra Elite IPK Document Revision 4
Programming Manual 2 - 597
___________________________________________________________________________________
___________________________________________________________________________________
 Notes 
Related Programming
M.B. Number Memory Block Name
1-1-03 Hold Recall Time Selection (Non-Exclusive Hold)
1-1-05 Start Time Selection
1-1-07 Tie Line Delay Ringing Time Selection
1-1-12 Station Transfer/Camp-On Recall Time Selection
1-1-37 Trunk Queuing Timeout Selection
1-1-63 Hold Recall Time Selection (Exclusive)
1-2-00 Internal Paging Timeout Selection
1-2-02 Automatic Callback Release Time Selection
1-2-22 Call Forward – No Answer Time Selection
1-2-23 System Call Park Recall Time Selection
1-4-02 Automated Attendant Transfer Delayed Ringing Time Selection
1-7-06 External Paging Timeout Selection
1. Telephone Ports 1 and 2 are in Station to Timer Class of Service, Class 1 by default. All other ports are in Station
to Timer Class of Service, Class 2 by default.
2. When a system is upgraded from R2500 or below, the related Memory Blocks above and the following are reset
to the default value during the upgrade process:
• 1-1-06 CO/PBX Incoming Ringing Alarm Time Selection
• 1-1-81 ISDN Dial Interval Time Selection
• 1-3-03 First Digit PBR Release Time Selection
• 1-4-01 Automated Attendant First Digit PBR Release Time Selection
• 1-4-03 Automated Attendant No Answer Disconnect Time Selection
• 1-7-01 Doorphone Display Time Selection
3. Telephone Ports A0~C0 are ports 100~120.