NEC Electra Elite IPK - Page 47

1 - 14 Multiline Terminal Programming
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
12 Station Transfer/Camp-On Recall
Time Selection
45s (R2500 or lower)
060s (R3000 or
higher)
25s, 45s, 60s, 90s, 120s, 180s, 240s,
∞ (No Limit) (R2500 or lower)
000s (No Limit), 001s~999s (R3000 or
higher)
13 CO Transfer Ring Pattern Selection C OFF, ON, A ~ H
14 CO Transfer Ring Tone Selection A A ~ H
18 System Speed Dial Restriction by
Tenant
CO/PBX Line LED
On
LED On: Not Restricted
LED Off: Restricted
20 DID Digit Length Selection 3 2, 3, or 4
21 DID Digit Conversion Assignment NO NO, YS
22 DID Digit Conversion Table T T (Station or Closed Number)
TN (Tenant)
23 DID Forward Station Number for
Busy Station or Undefined Digit
NON NON, T (TEL), TN (Tenant)
24 PBX/CTX Access Code Assignment
I
9– Up to six digits (three numeric, three
pauses)
25 PBX/CTX Access Code Assignment
II
8– Up to six digits (three numeric, three
pauses)
27 Automatic Day/Night Mode
Switching Time Assignment
Not Specified Day/Night Mode Time (24-hour clock)
28 Distinctive Ringing by Telephone or
CO Selection
TEL TEL, CO
29 Private Line Assignment Not Specified CO/PBX Line Number, Tel Port
Number
30 Route Advance Block Assignment All Blocks 00
(Not Set)
Priority of Trunk Group Number
32 Automatic Day/Night Mode by Day
of Week Selection
CO/PBX Line LED
Off Pattern 1
(Sunday ~ Saturday)
Pattern 1, Pattern 2
33 Speed Dial Number/Name Display
Selection
DIAL DIAL, NAME
34 Tie Line First Ring Pattern Selection PAT3 PAT1, PAT2, PAT3, PAT4, ICM,
VOICE
LK 1 System Mode
LK 1 CO Line (Continued)
Data
No.
Memory Block Name Default Value Programming Values