Electra Elite IPK Document Revision 4
Programming Manual 2 - 519
___________________________________________________________________________________
___________________________________________________________________________________
Notes
5 Repeat Steps 3 and 4 for each Line Key assignment. After Line Key No. 24 is programmed, the next Memory Block is displayed.
6 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
2-05
Line Key Selection (Tenant Mode)
1. When an Electra Elite IPK system is installed as a Key Function (KF) system, all COs must be assigned to the
line keys. Trunk groups, Route Advance Blocks and Least Cost Routing (LCR) cannot be assigned.
2. At system default, line keys 09~24 are not assigned.
3. Telephone ports A0~C0 are ports 100~120.
4. A minimum of two call appearance keys should be assigned to each PS II.
Programming Procedures (Continued)
To Next Page
Loading...
