2 - 518 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
3 Press the CO/PBX line key to select a function for Line Key No. 1, and use dial
keys to enter Setting Data 2 if required.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
C to go to the next page, or + to switch to page 2
A to go to the previous page, or = to switch to page 1
B +
A
to enter A for Port Numbers 100~109
B +
B
to enter B for Port Numbers 110~119
B +
C
to enter C for Port Number 120
For example, to assign Trunk Group 5 to CO/PBX line key 1, press LK7 to
display the TKGP, and enter 05 using the dial pad.
Default Values
For Tel 01~CO: LK01~08 Assigned to
CO/PBX lines 01~08.
4 Press G to write the data and display the next Line Key No.
Programming Procedures (Continued)
Setting Data Page 1
Line
Key
Functions
[For each telephone in tenant specified as
Telephone Mode in Memory Block 2-05 (Line
Key Selection)]
Setting Data 1
LCD Indication
Setting Data 2
1
Not Specified NON N/A
2
CO/PBX line CO 01~64
3
Call Forward – Busy/No Answer FW BNA N/A
4
Call Forward – All Call FW ALL N/A
5
Call Appearance Block C00~C47
(Call Appearance Block)
01~24
(Call Appearance Key)
6
Feature Access F A 01~16
7
Trunk Group TKGP 01~32
8
Route Advance ADV 01~32
Setting Data Page 2
1
Secondary Incoming Extension, including CAR SIE
Telephone Port No.
01~99, A0~C0
2
Microphone MIC N/A
3
Headset H SET N/A
4
Scroll Key for ANI/Caller ID SCROLL N/A
5
Do Not Disturb - Break Mode On/Off DND N/A
6
Log On/Off LOG N/A
7
Background Music On/Off BGM N/A
8
Intercom Key ICM N/A
To Next Page
Loading...
