NEC Electra Elite IPK - Page 107

2 - 30 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
 Notes 
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-20
DID Effective Digit Selection
1-1-21
DID Digit Conversion Assignment
1-1-23
DID Forward Station Number for Busy Station or Undefined Digit
5-00
Digit Add/Del For Tie Line Networking Assignment
1. When Memory Block 5-00 is used to add or delete digits on a trunk group, this Memory Block is used to route the
digits after the add or delete.
2. When converting a DID number to a Tenant, the following must be assigned to ring the desired station:
Memory Block 4-01 [CO/PBX Ring Assignment (Day Mode)]
Memory Block 4-02 [CO/PBX Ring Assignment (Night Mode)]
Memory Block 4-09 (Telephone to Tenant Assignment).
Programming Procedures (Continued)