Electra Elite IPK Document Revision 4
Programming Manual 2 - 79
___________________________________________________________________________________
___________________________________________________________________________________
Related Programming
Refer to Chapter 3 Advanced Applications, Section 1 Code Restriction on page 3-1.
Notes
Programming Procedures
4 Operation data includes:
5 Press
G to write the data and advance to the next Dial Code. After all Dial Codes for 8-Digit Matching Table 00 are entered,
press
G again to display 8 Digit Matching Table 01.
6 Repeat Steps 3 and 5 to cycle through all Dial Codes for all 8-Digit Matching Tables. After the last Dial Code for the last 8-Digit
Matching Table is entered, the next Memory Block is displayed.
7 Program the next Memory Block or press
E to go back on-line.
1. There are 16, 8-Digit Matching Tables. Each 8-digit table contains 16 Dial Codes. Each dial code can have eight
characters including digits and/or
,
, #, X, P, or N characters.
2. NANP = North American Numbering Plan.
Operation
Data
Dial Number Operation
X
K
~
I
,
J
,
L
B +
G
P
K
and
A
B +
H
N
B
~
I
B +
I
,
J
B +
J
#
L
B +
L
To Next Page
Loading...
