NEC Electra Elite IPK - Page 200

Electra Elite IPK Document Revision 4
Programming Manual 2 - 123
___________________________________________________________________________________
___________________________________________________________________________________
Display (R3000 or higher)
 Notes 
Programming Procedures
1 Go off-line.
2 Press LK1 + LK2 +
BB to access the Memory Block.
3 Use the dial pad to enter the Data Setting for Class 1.
Setting Data
01s~99s (e.g., 05s =5s)
Default Values
Class 1~4 = 12s
4 Press G to write the data and display the next Timer Class of Service.
5 Program the next Timer Class of Service or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-46
Access Code (1-Digit) Assignment
1-1-47
Access Code (2-Digit) Assignment
1-1-48
Access Code (3-Digit) Assignment
1-2-01
Intercom Call Voice/Tone Signal Selection
1-8-08
Class of Service (Station) Feature Selection 2
4-17
Station to Class of Service Feature Assignment
4-42
Call Forward-Busy Immediately/Delay Selection
4-71 Station to Timer Class of Service (R3000 or higher)
1. Telephone Ports 1 and 2 are in Station to Timer Class of Service, Class 1, by default. All other ports are in
Station to Timer Class of Service, Class 2, by default.
2. When a system is upgraded from R2500 or lower to R3000 or higher, the Call Forward – No Answer Time
Selection is reset to the default during the upgrade process.
2 2 : N O A N S 1 = 1 2 s
T I M E D I S P L A Y
T
i
me
r
C
la
s
s
1
~
4
Title
Data
No.
Setting
Data