Electra Elite IPK Document Revision 4
Programming Manual 2 - 153
___________________________________________________________________________________
___________________________________________________________________________________
Display (R3000 or higher)
Notes
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 +
J
+
A
to access the Memory Block.
3 Use the dial pad to enter the Data Setting for Class 1.
Setting Data
01s~99s (e.g., 02s = 2s)
Default Values
20s
4 Press G to write the data and display the next memory block.
5 Program the next memory block, or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
4-71
Station to Timer Class of Service (R3000 or higher)
1. After PBR is connected, dialing must be completed in the specified time. After the first digit is dialed, interdigit
time (default 7 sec.) controls the PBR time. Dialing the third digit exceeds the 20 sec. default, and the PBR is
disconnected.
2. R3000 or higher is required to adjust this memory block by 1-second intervals.
0 1 : A A P B R R L S 2 0 s
T I M E D I S P L A Y
Setting
Data
Data
No.
Title
To Next Page
Loading...
