NEC Electra Elite IPK - Page 271

2 - 194 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-7-02 External Speaker Connection
Selection
General Description
Use this Memory Block to specify whether or not external speakers are connected to
the system.
Display
Settings
 Notes 
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
default.
ESP A ESP B ESP C
Programming Procedures
1 Go off-line.
2 Press LK1 + LK7+
KB to access the Memory Block.
3 Press the CO/PBX line key corresponding to each ESP Zone. The LED changes to indicate the data each time the CO/PBX line
key is pressed.
4 Press
G to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-7-03
External Paging Alert Tone Selection
Only three external speaker zones can be connected to the system.
System Mode
1
Submode
7
Data No.
02
PC Programming
¦ +BP
0 2 : E S P C O N N
T I M E D I S P L A Y
Title
Data
No.
CO/PBX
Line LED
Off
On
Data No
Yes
The shaded area indicates
the default setting.