NEC Electra Elite IPK - Page 278

Electra Elite IPK Document Revision 4
Programming Manual 2 - 201
___________________________________________________________________________________
___________________________________________________________________________________
Display (R3000 or higher)
 Notes 
Programming Procedures
1 Go off-line.
2 Press LK1 + LK7 +
KF to access the Memory Block.
3 Use the dial pad to enter the Data Setting for Class 1.
Setting Data
000s~999s (e.g., 300s = 5m)
Default Values
Class 1~4 = 300s
000S = No Limit
4 Press G to write the data and display the next Timer Class of Service.
5 Program the next Timer Class of Service or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-2-00
Internal Paging Timeout Selection
1-7-02
External Speaker Connection Selection
4-71
Station to Timer Class of Service (R3000 or higher)
1. Types of paging include:
H All Internal Zone (51)
H Internal Zone Paging (52~54)
H External Zone Paging (all speakers) (55)
H External Zone Paging (individual speakers) (56~58)
H Internal/External Zone Paging (59)
2. Telephone ports 1 and 2 are in Station to Timer Class of Service, Class 1 by default. All other ports are in
Station to Timer Class of Service, Class 2 by default
(R3000 or higher).
3. When a system is upgraded from R2500 or lower to
R3000 or higher, the External Paging Timeout Selection is
reset to the default value during the upgrade process
.
0 6 : E S P T M R 1 = 3 0 0 s
T I M E D I S P L A Y
Timer
Class
1~4
Title
Data
No.
Setting
Data