NEC Electra Elite IPK - Page 312

Electra Elite IPK Document Revision 4
Programming Manual 2 - 235
___________________________________________________________________________________
___________________________________________________________________________________
Installation Procedure for the Voice Mail ETU
1. Verify that the battery is connected to CN4.
2. Turn off the KSU system power.
3. Wearing a grounding strap, place the Shutdown Switch on the voice mail ETU in RUN or, if equipped, place the MB
Switch to ON.
4. Install the voice mail ETU in the KSU.
5. Turn the KSU power ON.
5 Program next Memory Block or press E to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-46
Access Code (1-Digit) Assignment
1-1-47
Access Code (2-Digit) Assignment
1-1-48
Access Code (3-Digit) Assignment
1-2-03
2~7-Digit Station Number Selection
1-2-24
Intercom Feature Access Code Assignment
1-2-34
Expanded Station Number Assignment
4-10
Station Number Assignment
4-14
Intercom Master Hunt Number Selection
4-15
Intercom Master Hunt Number Forward Assignment
4-35
Voice Mail/SLT Selection
Programming Procedures
The following procedure must be followed every time the Voice Mail
ETU is to be inserted into the KSU.