Programming Manual 1 - 1
___________________________________________________________________________________
___________________________________________________________________________________
Multiline Terminal
Programming Chapter 1
SECTION 1 GENERAL INFORMATION
A stored program controls the Electra Elite IPK system. When the system is initially
powered up, the CPUI( )-U( ) ETU scans all interface and AP slots to determine the
hardware configuration. The system stores this information and the default values in
the resident system program memory. After initially powering up the system, a trained
technician can change the resident system program to meet the specific needs of an
individual customer.
SECTION 2 PROGRAMMING THE SYSTEM
System data programming may be necessary when:
H
the system is installed for the first time.
H
components of an existing system are replaced.
H
functions of an existing system are changed.
The battery on the CPU must be connected. When the battery is not
connected before programming begins, data may be lost when a
power outage occurs.
To Next Page
Loading...
