2 - 360 Memory Blocks
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-15-13 Centralized Day/Night Switching for
Remote Office Assignment
General Description
Use this Memory Block to assign the Electra Elite IPK to switch Day/Night mode when
it receives the command from a main office.
Display
Settings
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
The shaded
selection is the
default.
Deny
(NO)
Allow
(YS)
Programming Procedures
1 Go off-line.
2 Press LK1 + LK15 +
AC
to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press
G to write the data, and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1
Card Interface Slot Assignment
7-3-01
MIF (LCR) Assignment
7-3-02
MIF (SMDR) Assignment
1-15-00
K-CCIS Main/Remote Office Selection
1-15-01
Common Signal Channel Data Speed Assignment
1-15-02
Common Signal Channel Assignment
1-15-03
Originating Point Code Assignment
1-15-04
Destination Point Code Assignment
1-15-05
Destination Point Code Transfer Assignment
1-15-06
Originating Office Code Number Assignment
System Mode
1
Submode
15
Data No.
13
PC Programming
¦
+AW
1 3 : C E N D / N N O
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
To Next Page
Loading...
