Electra Elite IPK Document Revision 4
Programming Manual 2 - 389
___________________________________________________________________________________
___________________________________________________________________________________
1-16-05 Default VLAN ID Tag Insertion
Assignment
General Description
Use this Memory Block to insert VLAN ID tagging to data frames from network devices
that cannot insert VLAN tags. When data without a VLAN tag is transmitted by the
device on the port, a tag is inserted with the VLAN ID assigned by this Memory Block.
R1500 or higher is required.
Display
Programming Procedures
1 Go off-line.
2 Press LK1 + LK16 +
JJKE
to access the Memory Block.
3 Use dial pad keys to enter Setting data.
Use the following to enter data:
Use
J
to move cursor left
Use
L
to move cursor right
Use
K
~
I
to enter numeric data
VLAN ID range is 0001~4095 (0x001~ 0xfff Hex).
Default Values
:
All ports = 0001
4 Press G to write the data.
5 Repeat steps 3 and 4 for each port.
6 Press
E to go back on-line.
System Mode
1
Submode
16
Data No.
05
PC Programming
¦
+AB
0 5 : 1 - 1 I D = 0 0 0 1
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
PORT
1~8
HUB
1~3
To Next Page
Loading...
