NEC Electra Elite IPK - Page 49

1 - 16 Multiline Terminal Programming
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
63 Hold Recall Time Selection
(Exclusive)
1.0 (R2500 or lower)
060s (R3000 or
higher)
In minutes: 0.5, 1.0, 1.5, 2.0, 3.0,
5.0, 8.0, ∞ (No Limit) (R2500 or lower)
000s (No Limit), 001s~999s (R3000 or
higher)
65 Code Restriction Class Allow/Deny
Selection
Class 01 ~ 04 – YS
Class 05 ~ 14 – NO
YS (Allow)
NO (Deny)
66 8-Digit Matching Table to Normal
Dial Assignment
Tables 00 ~ 14 =
Used
(All CO/PBX Line
LEDs On)
Table 15 = Unused
(CO/PBX Line LED
Off)
N/A
67 OCC Table Assignment Tables 00 ~ 15 =
Blank
Table 16 =
1010XXX
N/A
68 8-Digit Matching Table to OCC
Table Assignment
CO/PBX Line LED
Off
Refer to 1-1-68 8-Digit Matching Table
to OCC Table Assignment on page
2-88.
69 Tie Line Code Restriction
Assignment
YS NO = No Restriction
YS = Restriction
70 Code Restriction Class Assignment
when Lockout is Set
15 Class 00 ~ 15
71 First Delay Announcement Start
Time Selection
20 In seconds: 00, 10, 20, 30, 40, 50, 60
72 First Delay Announcement Repeat
Selection
1 1, 2, 3, 4, 5, 6, 7, 8
73 First to Second Delay
Announcement Interval Time
Selection
20 In seconds: 00, 10, 20, 30, 40, 50, 60,
∞ (No Limit)
74 Second Delay Announcement
Repeat Selection
1 1~ 8
75 Second Delay Announcement
Repeat Interval Time Selection
20 In seconds: 00, 10, 20, 30, 40, 50, 60,
∞ (No Limit)
76 Barge-In Alert Tone Assignment YS YS = Send Alert Tone
NO = Do not send Alert Tone
LK 1 System Mode
LK 1 CO Line (Continued)
Data
No.
Memory Block Name Default Value Programming Values