Electra Elite IPK Document Revision 4
Programming Manual 2 - 445
___________________________________________________________________________________
___________________________________________________________________________________
Notes
3 Press the corresponding CO/PBX line key to change incoming signal detect time for CO/PBX No.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
C to go to the next page
A to go to the previous page
4 Press
G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Related Programming
M.B. Number Memory Block Name
3-14
Tie/DID Line Type Assignment
1. For second dial tone and immediate loop supervision, the time is fixed at 30 ms.
2. This Memory Block affects T1 channels assigned as Tie/DID lines.
Programming Procedures
Sending Acknowledgment Signal
Incoming Signal Detection
Time
DC Loop Supervision
Receiving Side
To Next Page
Loading...
