NEC Electra Elite IPK - Page 581

2 - 504 Memory Blocks
___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
 Notes 
Page 6 – Trunks 41~48
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
41 42 43 44 45 46 47 48
Page 7 – Trunks 49~56)
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
49 50 51 52 53 54 55 56
Page 8 – Trunks 57~64)
LK 1LK 2LK 3LK 4LK 5LK 6LK 7LK 8
57 58 59 60 61 62 63 64
Programming Procedures
1 Go off-line.
2 Press LK4 +
KB to access the Memory Block.
3 Press the CO/PBX Line key to select night ring assignment for Tel Port No.
The LED indication changes to indicate data each time a CO/PBX line key is pressed.
 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
C to go to the next page
A to go to the previous page
Default Values
CO/PBX lines 01 ~ 08 ring at Tel Port
numbers 01 and 02.
Tel Port numbers 03 ~ 120 do not ring
on any incoming CO/PBX calls.
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
Telephone ports A0~C0 are ports 100~120. Refer to Settings 1 to enter ports A0~C0.
CO/PBX Line
Key LED
Off Green Red
Data No Ring
Immediate
Ring
Delayed
Ring