Electra Elite IPK Document Revision 4
Programming Manual 2 - 531
___________________________________________________________________________________
___________________________________________________________________________________
Notes
3 Press the CO/PBX line key corresponding to each CO/PBX line.
The LED indication changes to indicate data each time a CO/PBX line key is pressed.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
C to go to the next page
A to go to the previous page
H to clear data when cursor is at setting data position
B +
A
to enter A for Port Numbers 100~109
B +
B
to enter B for Port Numbers 110~119
B +
C
to enter C for Port Number 120
Default Values
Not Restricted
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press
E to go back on-line.
1. A restricted CO/PBX line allows the station user to answer an incoming call or access a held call, but does not
allow a user to originate a CO/PBX call.
2. When restricted is specified in this section, the data in Memory Blocks 4-07 [Code Restriction Class Assignment
(Day Mode)] and Memory Block 4-08 [Code Restriction Class Assignment (Night Mode)] is treated as invalid
even if specified.
3. Telephone ports A0~C0 are ports 100~120.
Programming Procedures (Continued)
CO/PBX
Line Key LED
Off On
Data Not Restricted Restricted
The shaded selection
is the default.
To Next Page
Loading...
