Electra Elite IPK Document Revision 4
Programming Manual 2 - 591
___________________________________________________________________________________
___________________________________________________________________________________
Notes
1. Telephone Ports A0~C0 are ports 100~120.
2. The name can be entered using the dial pad. Follow the procedures in Appendix B Character Codes.
3. The default names listed in the table below are assigned based on the line key type from Memory Block 4-12
(Line Key Selection for Telephone Mode).
LK Assign Default Note
NON (not assigned) All Blank
CO Outside Lines CO^xx xx=Port 01~64
Call Forward – Busy/No Answer CFB
Call Forward – All Calls CFA
Call Appearance Keys (CAP) CAPxx-yy
xx=Block 00~47
yy=Key 01~24
Programmable One-Touch Keys FA xx xx=key 01~24
Trunk Group TKGP^xx xx=Trunk Group 01~32
Route Advance Group ADV^xx xx=Group 01~16
SIE including CAR SIE^xxx xxx=Port No. 01~99, AO~CO
Microphone MIC
Headset On/Off Key HSET
Scroll Key for Caller ID indication SCROLL
Do Not Disturb On/Off DND
Log On/Off LOG
BGM On/Off BGM
Intercom Key ICM
To Next Page
Loading...
